Full Set Wheel Hub Bearing Front Rear For 2014-2016 Chevrolet Impala Buick Regal
Fits LH (Driver Side) & RH (Passenger Side) Front & Rear. Includes ABS with Tone Ring Sensor. Brand New Wheel Hub Assembly. Built to strict quality control standards. Fits LH (Driver Side) & RH (Passenger Side).
(2017 Except Brake Code J55). Fits 2016 Chevrolet Malibu Limited. Remove the bolt (1) and separate the front wheel sensor from the steering knuckle. Remove brake caliper torque member bolts, leaving brake hose attached, reposition the caliper aside with wire.
Put alignment marks (A) on disc brake rotor and wheel hub and bearing. Remove cotter pin and the nut retainer, Loosen the wheel hub lock nut from the drive shaft using power tool. Using a piece of wood and a suitable tool, tap on the lock nut to disengage the drive shaft from the wheel hub and bearing.
Remove the engine side cover. Remove the lower nut and bolt from the steering knuckle, Separate transverse link from steering knuckle. Separate drive shaft from wheel hub and bearing, Reposition the drive shaft aside with wire.
Remove the wheel hub and bearing bolts using power tool. Remove the splash guard and the wheel hub and bearing from the steering knuckle. Failure to separate the front wheel sensor from the steering knuckle may result in damage to the front wheel sensor. Pull out the front wheel sensor, being careful to turn it as little as possible. Do not pull on wheel sensorharness. Inspection after removel : Check components for deformationy, cracksy, and other damagey, and boots of transverse link ball joint for cracksy, axial end play, and swing torque. Installation is in the reverse order of the removal. Do not reuse the wheel stud. Do not reuse the cotter pin. Place a washer (A) as shown to install the wheel studs (1) by using the tightening force of the nut (B). Clean the mating surfaces of the joint sub-assembly and the wheel hub and bearing. Apply lubricant to the surface (A) of the joint sub-assembly. Hold the wheel hub and bearing using a suitable tool. Tighten the wheel hub lock nut. Since the drive shaft is assembled by press-fitting, use a torque wrench to tighten the wheel hub lock nut. Do not use a power tool. Too much torque causes axle noise. Too little torque causes wheel bearing looseness. Tighten the wheel hub lock nut to the specification. When installing a the cotter pin (1) and the nut retainer (2), securely bend the cotter pin to prevent rattles. Align the matching marks (A) on the disc brake rotor and on the wheel hub and bearing. Wheel Hub & Bearing Assembly. Has ABS with Tone Ring Sensor. Front Wheel Hub Bearing For Chevy Monte Carlo Impala Cadillac Eldorado DTS FWD. Universal 12V Low Pressure 5-9 PSI Electric Fuel Pump Installation Kit E8012S. ECCPP 2 Pcs Wheel Hub Bearing Front For Buick LaCrosse Century Regal Lesabre FWD. Drive Shaft And Half Shaft. 4 Pcs Wheel Hub Bearing. ATV/UTV CV Axles & Parts. C Notch & Flip Kit.Engine Gasket & Cylinder Head. Fuel Tank Pipe & Cap. Fuel Tank Valve & Regulator. Hydraulic Lifter & Rocker Arms.
Ignition Coil & Spark Plug. For Honda Civic CX DX GX LX HX S Si CRX DX VX Front 240 mm Brake Disc Rotors Kit. Front Brake Discs Rotors For Chevrolet Cruze Chevrolet Sonic Chevrolet Volt. Ceramic Brake Pads And Rotors Front Rear For HYUNDAI SONATA KIA OPTIMA.