Placement on Vehicle:Driver Side or Passenger Side FRONT and REAR. For Chevrolet Impala 2000 - 2013 All Models With ABS. For Chevrolet Monte Carlo 2000 - 2007 All Models With ABS.
For Chevrolet Venture 1997 - 2005 Fwd Models With ABS. For Pontiac Aztek 2001 - 2002 Fwd Models With ABS.
For Pontiac Montana 1999 - 2005 Fwd Models With ABS. 4x Front Rear Wheel Bearing Hub Assy For 2000-13 Chevy Impala Monte Carlo w/ABS. Placement on Vehicle:Driver Side or Passenger Side. For Pontiac Grand Prix 1997 - 2008 All Models With ABS.
For Buick Regal 1997 - 2004 All Models With ABS. For Buick Century 2004 - 2005 All Models With ABS. When do you need to replace. Poor Clicking, snapping or popping. Shimmy, shudder, or vibration at constant speeds. Abnormal side pulling when applying brakes. Uneven or abnormal tire wear.Loosen the lug nuts on the wheel of the hub bearing you're replacing with the breaking bar and a socket. Lift the wheel with the floor jack in a safe and secure manner. Support the vehicle on a jack stand. Remove the lug nuts and wheel. Locate the caliper bolts and remove them with the ratchet and a socket.
Pry the caliper off gently using a large straight-edged screwdriver and support the caliper on the coil spring with a bungee cord. Locate the caliper bridge bolts (if applicable) and remove them with the ratchet and a socket. Remove any ABS wires attached to the hub bearing assembly (if applicable) or unclip the wire and trace it to the plug. Remove the spindle nut with the breaking bar and a spindle nut socket. Remove the washer behind the spindle nut. Locate the wheel-bearing assembly bolts behind the knuckle, and loosen them with the breaking bar and socket. Install the slide hammer onto the lug studs and secure with tightened lug nuts.Sand off the rust and corrosion around the knuckle with a fine- to medium-grade sandpaper. Place the backing plate in its original position and place the new bearing onto the knuckle. Replace the wheel-bearing assembly bolts. Replace washer and spindle nut and tighten to proper torque specifications with the half-inch drive torque wrench and spindle socket. Replace the brakes in the same manner you extracted them.
The tire and lug nuts, and tighten the lug nuts as tight as you can get them. Lower the vehicle and tighten the lug nuts in an alternate fashion with the torque wrench and socket at the correct wheel nut specifications torque setting.We are galde to offer quality service and vehicle parts to you, any sale questions please message us before open case or feedback, we will give you the best solution. Wheel Hub & Bearing Assembly.
Are always here to answer the question and solve the problem. Please DO check the compatible chart before placing orders to make sure it fits your vehicle.
4 pcs Wheel hub Bearing. Door Handle Inside Interior Driver Left LH For Chevy C1500 Truck Suburban K2500.130PSI 12V Air Compressor Kit For Train Horns Air Horn Air Suspension Kit. 4 pcs1.5 8x6.5 to 8x180 8 Lug Wheel Spacers Adapter For CHEVY GMC Savana 2500. 2 pcs Front ABS Wheel Speed Sensor For Dodge Journey For Chrysler. Door Lock Actuator Motor Front Left Right For Nissan 98-15.